1. Calibration Dvd
2. Cleansweep Calibration Cd

The “Power Calibration Error” typically appears when someone attempts to burn a CD or DVD and the burner fails to write the CD or DVD. The error might also appear as a “Medium Speed Error.”Ambe vocoder software.

Multiple factors can cause the error, but it is most likely to occur because the CD/DVD burner is not able to determine the Optimum Power Calibration rate. The Optimum Power Calibration rate is a test that is run before burning a CD or DVD to determine the optimal laser power needed to write the CD or DVD. When this cannot be determined, the disk burn fails. The “Power Calibration Error” can also appear for minor reasons that can be easily fixed.

Options for Fixing the “Power Calibration Error”

It is very difficult to figure out exactly what causes the “Power Calibration Error.” There are a few ways to fix it, so the best thing to do is try the different fixes until one works.

Use the options below to fix the “Power Calibration Error:”

Each input features a line-level or speaker-level switch and adjustment potentiometers with calibration lights to aid in level-matching. Use of the CleanSweep Calibration CD is required for level-matching. The CL-SSI provides a direct plug-in output harness for connection to the input plug of the CL441dsp. Find the JL Audio CleanSweep CD and other Car Audio OEM Interface Accessories at the official JL Audio site. A specific calibration track is necessary for a successful calibration of any of the OEM integration DSP products. Select the product you need to calibrate from the list below to download the correct calibration track. You can also purchase a Calibration CD containing these tones along with additional test tones and helpful system tuning.

1. A common reason for this error is cheap blank media. Try using different brands of quality blank media to solve the error. Some good brands to use are JVC, Verbatim, and Falcon.
2. It is usually very effective to burn at lower speeds.
3. It is a good idea to check with Sony to find out if there is a firmware upgrade for the CD or DVD.
4. Try updating the CD/DVD burning software to the most recent version.
5. Try cleaning the disk drive. Make sure there are no dust particles or bits of paper.
6. If the options above do not work, disable the Image Mastering Applications Programming Interface (IMAPI) Service. This service manages CD and DVD recordings. To disable IMAPI service, follow these steps:

a. Launch the Control Panel, click Administrative Tools, then click Services.

b. Browse for “IMAPI CD-Burning COM Service.” Once found, right-click it and select Properties.

c. Change the Startup Type to Disabled.

d. Click Apply and then Reboot.

7. If none of the above options works, it is most likely a hardware problem and not a software problem. At this point, it is a good idea to get the burner laser lens cleaned professionally.
8. If every option fails, then the driver’s laser probably died and needs to be replaced.

Calibration Dvd

Item specifics

Cleansweep Calibration Cd